Overhead Garage Storage Racks & Wall Shelving
Custom Garage Storage SolutionsQuote & Install Same Day!
Custom Garage Storage Solutions
Affordable Ceiling Storage Racks has installed over 10,000 garage storage shelves in the Phoenix Valley. Completely customizable, our prices reflect our products only which include the following.
Please note that we do not offer totes, lights, or wall-mounted organization products.
All of our ceiling racks are framed with perforated steel perfect for accessory hooks. Our hooks fit firmly in the perforated holes on the bottom of the rack and have a 50 lb. weight limit per hook.
Accessory hooks are most often used for bicycles, ladders and folding chairs, and more.
.jpg?1563901359664 "Overhead storage racks with bike hangers")
Our heavy-duty shelving units are more durable and affordable than typical garage cabinets. Each shelf is mounted directly to the studs in your wall and has a floor support every 4’.
An average-sized man can easily climb up these shelving units and they can support an enormous amount of weight. They are installed in 8’ sections, up to 2’ deep-set to any height on the wall. These shelves are 100% framed in galvanized steel with a powder-coated steel grid and have a 1-1/4” Lip around all sides.
Three 4ft. X 8ft. Overhead Ceiling Storage Racks, Eleven Heavy Duty Steel Shelves
Prompt service, excellent product, reasonable prices. You cannot go wrong with these guys. Philip my installer was a real professional. Would not hesitate to use them again.
- David F.
I had lots of choices but I selected this company based upon the reviews. Phillip came out as the installer but that was a little different from what I thought was going to happen. I had understood that the gentleman I was talking to on the phone was going to do the installation. Not a big deal, Phillip came out and did a fine job. He was neat and efficient putting up two 4x8 racks for me. He then did a custom job on my other bay with a couple of narrow runners. For the do-it-yourselfers, which I am one, this is definitely not a job you want to do yourself. To be on a ladder in 110 degree heat driving 3 inch lag bolts upward into 2x4s and making sure the job is straight and professional is definitely something a do-it-yourselfer does not want to do. There is also a good deal of cutting of the angle iron to be the exact length and making sure that it's properly installed again is something you don't want to do on a ladder. Good job! The product is solid and a good quality. However the cost in this solution is in the labor, know how, and the professionalism. Pay for it.
- Steve H.